IMG_20170904_111229.pdf [666.32kb] Good afternoon to those who can read me, I have a Wirlpool 110 refrigerator model WRNE322 for about 15 years installed in a cottage that we visited no longer as often as we used to do, the fact is that with a certain frequency (once a year I could say) when it came to spend a few days I found that the refrigerator did not cool but the engine was working, the first time this happened I called a technician in the area and this dismantled the plastic back plate and I took a relay which I replaced and ready, after a few minutes you could see which was already beginning to cool; this same happened to me in 3 or 4 opportunities but as I already knew what the failure might be, before calling someone I bought a relay and placed it and saved me money. This week I did not run with the same luck because I found that at some point there was a short circuit, and I will give more details. He had said that except for this last time when I found the refrigerator without cooling the engine was kept on, this Embraco engine has on the top a plastic tray that collects water from the thaw, I had noticed that this tray had deformed in its ends, rather as melted; then in this last opportunity I suppose that it happened exactly the same with the difference that the tray had water and this when not being retained falls directly on the place where the relays go, result short circuit, all singed, the cover of the relays, the own ones cables, thank God did not happen to older, but in the short a cable had to stay stuck on some of these pins and ate almost completely, then the thermal relay (a single pin) fails to make contact with the leg as small as it gets. The question specifically is if someone could tell me if this has repair, replacement or definitely the engine can no longer be used. I appreciate your comments

fernando if the pins of the relay are destroyed as you mentioned change it for a new one, and if they destroyed the motor pins you would have to change the understanding motor is not so clear your question, as the tecnico2015 design should upload a photo to give you a suggestion luck

this too short friend the best change the compressor

Hi, how are you, a possible solution is to solder with tin a male hollow bronze pin if you weld well you will be able to use that engine without problems, greetings. /20/3dcaa51547df3461de72db0edb41b8a902ac7aad.png[/img]

Hello, solution without so many words. 1 cautil goot 60w as minimum or of good power, pasta but tin 2 flex cable number 12 a good and very professional welding with coating of temperature regards