IMAGE 7.jpg [20.59kb] Ralesme. The photo is not focused and the question is not clear.-What do you want to know? How can you help with what you wrote? nothing is understood Start by writing what you want to solve, then write the data of the refrigerator, if it is 2 vertical door or floodgates up and down, if the freezer is up, down or sideways, some photos, the problem that the refrigerator has a photo of the defrost card and photo of how you installed the clock with the card. Normally if a stop clock is added, it works with defrosting and the card starts the engine again by turning off the clock until the next stop, so the card controls the clock and the clock defrosts it with the time the card gives it keeping the resistance on until the ice is removed and the bimetallic sensor turns off the resistance. Load more data please I can't copy the plane of the refrigerator and yours is blurry, in which I opened, I think it's the same, Starting at the entrance. Orange is the common for everything (neutral) and on the left side the coffee is the phase for everything. Orange enters the evaporator fan and on the other side has a black wire that goes through the door's suiche and goes to terminal O of the electronic card and also goes to the bimetallic of the compressor and the common one of the same, bone of the card feeds with black compressor and evaporator fan the ORANGE enters the electronic card in terminal N the solito The ORANGE enters the BIMETALIC, leaves with PINK to the RESISTANCE where it leaves with BLUE and goes to the D of the card The brown cable of the DIRECT line enters the terminal L of the card If you still have the card in place, these are the connections you have to make even if you have used different colored cables, you must respect the connection plan