There is an air conditioner which repaired the leak, but they sent pressure to the system to detect it. The system had already been cleaned to the system ... The fact is that it was loaded until it was 70 psi low with a consumption of 19 amp .... Currently, the same pressure again went down to 40 psi and consumed 12 amp .. It is thought to be another leak but when the pressure was turned off it reached 180 psi ... This means that the air has enough refrigerant, now I observe that the filter gets cold until it is time to produce water .. What may be happening I appreciate some answers to the case

Hi Mario: The fact that when the equipment is switched off the low pressure reaches 180 psi does not mean that it is properly loaded. It is much more important the fact that in low and with the equipment running you have 40 psi and 12A ° of consumption, that alone and if there is no other sign would be a lack of refrigerant, even the liquid or high pipe would have to be cold or frosty. Luck, comment your results.

By gas I do not believe because the refrigerant was recovered and was complete .. The air had been working on its parameters (70psi 25 amp) but it was turned off to put it in place I present that problem ...