⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Air conditioner

Klixon AA 9000BTU fault

Luisben507

hace 5 años

Good morning, colleagues, I'm new to the forum and I appreciate your help. I tell you that today I changed the starting capacitor of a 9000 btu split which was burned but the thermo protector continues to jump. I measured its continuity and it's OK anyway I think the bimetal was weakened since several days ago I had the capacitor burned and the owners of the team had it constantly on so the engine tried to start continuously. Do you agree that the klixon is the problem and in that case what values do I take to buy a new klixon? Thank you very much greetings!

Comentar



refricurioso

222

hace 5 años



hace 5 años

good luis you should check the amperage of the compressor .... did you measure continuity to the compressor? it is possible that this is blocked and that is why the thermal jumps

Comentar

Luisben507

hace 5 años

Hi, cool.
It does not let me check the compressor's ameje because the thermal jumps at the moment it connects the relay on the board.
I did not measure continuity to the compressor ...
I really played it for the klixon but now I'm not sure maybe I should do more tests on the engine.
I have a klixon of a 12000 team I can test if it starts with this klixon or I need if or if one with the same parameters



Responder

refricurioso

222

hace 5 años

if it jumps at the time of starting it is possible that the compressor is grounded .... you tried it!



Responder

Luisben507

hace 5 años

I did not try it.
Tomorrow I will return to the place and I will do the tests that you recommend.
Then I tell you how it went ...
The zumba engine wants to start and the klixon jumps. Maybe you're right and it's the engine
Thank you
regards



Responder

Luisben507

hace 5 años

Hello, you were right, the engine was grounded.
I appreciate the help greetings



Responder

pablo lamas

2.661

hace 5 años

Hello, you must measure the amperage, in that attempt to start and if it consumes more than adequate, then it is damaged, of course you must do it with caution, take the measures to disconnect it quickly, if it does not start and well you can try with the thermal that you have available , regards.

Comentar

Luisben507

hace 5 años

Hi Pablo, thanks for your answer
I'm going to check the engine as proposed.
And I'll take extra klixon to test it if everything goes well with the engine.
regards



Responder