⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Air conditioner

The air conditioner is not in hot mode

Josemaria
hace 5 años
hace 5 años
Hi, I have a Kelvinator 2600 refrigeration air conditioner ... in cold mode it suits me perfectly ... I pass it to heat mode and only the outer part starts to heat up the pipe, the indoor unit coil also heats up ... but it does not start. .. What can it be ??? thank you very much
Comentar
Geko
Geko
Geko
591
hace 5 años
hace 5 años
Hello, how long did you leave it in heat? Because there are teams that take more than 10 minutes to open. If you waited and never opened it is surely the well sensor. Regards.-
Comentar
Josemaria
hace 5 años

Hi, thank you very much everyone ... I tried the sensors and they were fine .. I placed them and waited a little longer than ever and walked away ... I didn't understand why it always started fast .. excuse me ignorance thank you

Responder
tonga76
tonga76
tonga76
981
hace 5 años
hace 5 años
Q does not start? The compressor? The forcer? The turbine? How do you know that cold is good?
Comentar
Josemaria
hace 5 años

The outdoor unit starts well what does not start is the inner part ... In cold mode it is good why I used it. And when I switch it to heat mode, only the outer part starts ...

Responder
omorma
omorma
omorma
15.708
hace 5 años
hace 5 años
Hello how are you, change the contact sensor is out of value or improperly connected the tab or zulfatada so it does not start the interior turbine does not record the temperature greetings.
Comentar
Josemaria
hace 5 años

Ah you mean the one that goes inside the pipe or the environment ... Now I see if the card is well connected if the changes are well connected tomorrow and I warn you ...

Responder
tonga76
tonga76
tonga76
981
hace 5 años

The sensor the colleague omorna tells you must be failing.

Responder
Josemaria
hace 5 años

Ah well ... I now look at the card ... If it is badly connected ... if I do not take them out and test them with the tester ... if they are failing ... Thank you very much

Responder
TRIATLON99
TRIATLON99
TRIATLON99
6.267
hace 5 años

Hi that team uses 5000 omhs sensor.

Responder
enzocar
enzocar
enzocar
989
hace 5 años
hace 5 años
How are you? As colleagues almost certainly say it is the well sensor. The one that goes in the evaporator pipe.
Comentar
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.93
(14)

Curso Reparación de Equipos de Audio de Alta Fidelidad
Maximiliano Resch
$ 60 USD
$ 20 USD
COMPRAR
4.25
(8)

Reparación de Placa Main TV LED con el Ing. Picerno
Ing. Alberto H. Picerno
$ 40 USD
$ 20 USD
COMPRAR
4.71
(7)

Curso TV OLED y QLED con el Ing. Picerno
Ing. Alberto H. Picerno
$ 29 USD
$ 10 USD
COMPRAR
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis