Good Mr. Alejandro and those measurements you are giving are very good and everything is reread according to coil calculations, electrically the compressor is in good condition and you just have to measure the grounding that the compressor is not grounded. I imagine that you already measured the gear capacitor and used a capacitometer to check it according to the data in Microfarads that is on the capacitor's label. also verifying that the voltage is in the operating limits. then it must be that the compressor is locked or stuck and to unlock it you must use a startkit and connect it in parallel at the capacitor terminals or a startkit cable on a pole of the gear capacitor and the other startkit cable on the another pole of the gear capacitor. You can also do the following, have a 220 volt and 88uf start capacitor on hand, the starter capacitor connects 2 wires one on each side and then you go to the gear capacitor and only make contact with the 2 wires on each one of the poles of the gear capacitor and is only contact and not leave them fixed and then send another person to turn on the air conditioner and when the compressor turns on or you feel that you turned on the 2 wires of the gear capacitor and ready there you should If the compressor is running (eye is going to drop sparks on the contacts) and ready there the compressor should work Friend comments here to guide you.