I have a mirage absolut X minisplits of 26000 btu model EXC261D left on 2 days with their nights and turned off only suddenly, and could not be turned on, the cause was a short in the cables (a meter away) that feed the condensing unit; Here, in this section of the short film, a 3-wire connection had been made because it had not reached the condensing unit, the excess temperature of these cables melted the insulating tape, hairs were left and they became short. The fuse of the electronic board was blown, it was changed and it did not turn on, the electronic board was changed and it did not turn on, the transformer was checked and it works, the thermics of the box were changed, (it takes 2 of 115 volts, since the a / c is 220 v) and it did not turn on, the contactor was changed and it did not turn on, it is not seen to carry the thermal sensor on the outside, in the compressor, and I DO NOT know what else I can check. Could you help me with some suggestions? Thanks in advance for the inconvenience and receive a greeting !!!!

Hello Check the communication cables. The high short circuit current could melt a cable at a different point than the short one. As the power surely enters through the condenser, the fault would have to be sought from the condenser I suggest you change the cables directly. Step followed if there was no problem seeing power cables (complete circuit) for the same reason Comment PD: The power cables are not spliced, such practice is prohibited, if the cable is short it is discarded and a longer one is placed