⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Air conditioner

amount of pipe in air conditioning

ivan salvia

hace 6 años

When I am going to install an air I have to put a pipe on it, can it be of any length? or it has to have a certain measure example: R22 carries 1 meter of pipe * this is an example I am not saying that r22 leads .... * please if you want to tell me the models and quantity of pipe that each air carries thanks

Comentar

TRIATLON99

6.267

hace 6 años

Hello, what is required by the warranty on equipment with r 410 a is three meters.
From 2 meters of pipe work very well, the important thing is to control the pressure after 15 'of walking, in both modes.
With r 22 from 1.5 meters.
Regards



Responder

TRIATLON99

6.267

hace 6 años



Responder

omorma

15.708

hace 6 años

Hello how are you, minimum 3 meters as indicated by all manufacturers, up to 5 meters without adding coolant more than 5 meters of additional 20 to 30 grams per meter added greetings.

Comentar



duglas

1.680

hace 6 años



hace 6 años

A normal split pipe is 3 mt from there for every meter whose additions are like 20 to 30g additional. but you can add the meters you want you can load by calculating 20g per additional meter and if you turn on the air in cold mode to adequate temp of 28 g of ambient temp to the lower temp and be guided by the pressure in r22 it has to work from 60 to 65 psi with any amount of additional pipe and r410 at 115 or 120 psi Greetings friend I hope it helps you.

Comentar

Ricardo Ab.

5.181

hace 6 años

Hello duglas, allow me to disagree to avoid confusion. According to the manual of the equipment, they have a minimum and a maximum, although as omorma points out, it is between three (minimum) and five (maximum) after which you have to add refrigerant per added meter you cannot put twenty meters of pipe and not only that It also depends on whether the distance is horizontal or vertical. Clarified that I will add that depending on the distance you have to change the diameter of the pipe and it will be seen if oil retention roller is needed. Well in short the thing is not so simple, you have to know.



Responder

duglas

1.680

hace 6 años

If you are right Ricardo, I apologize for not having added that comment that as the meters increase, the section of the pipe is a thousand apologies to the consultant and you my dear friend



Responder

duglas

1.680

hace 6 años

If you are right Ricardo, I apologize for not having added that comment that as the meters increase, the section of the pipe is a thousand apologies to the consultant and you my dear friend



Responder

ANGEL MATA 01

hace 6 años

If I remember correctly for every 3 meters you have to make a U to the pipe when the pipe goes vertical because otherwise the oil will not return to the condenser. And for every additional meter of pipe it is around 25 to 30g depending on the diameter What you need to keep in mind is that it is turned on at 60 to 65psi for R22 and the manufacturer indicates.

Comentar