Hi. Good Morning: Can anyone support me? I have the following problem: Until Thursday 11/16/2017 I managed to print on an LX-300 + ii and as I had finished printing, I left the printer on and about three hours later I needed another print. Place the sheet to be printed - when using single sheets, I proceeded to generate the file on the screen and send it directly to the printer in reference (I have it as pre-determined), but did not print anything. Then I sent it again and nothing, so I turned off the computer and turned it on again, I sent the print again, but nothing. Since that day I have been looking for a way to get it printed again, but nothing. Looking for other suggestions, with the guide they indicate, the printer was able to print a sheet that starts like this: Draf and I open lines like this: '"** $" / &' () * ... / 0123456789 ;; <:: ::>? @ ABCDEFGHIJKLMNOPQRTUVWXZ April and close square brackets and then the lowercase alphabet on the entire sheet and where it starts with Current settings, which was achieved by pressing tear off + load / eject key simultaneously and pressing on, but nothing. I don't know how to print again. Maybe someone can help me. Thank you. Sincerely, Jorge Pérez

What you printed is the test that comes inside the printer with that it is known if the printer is working well in terms of its mechanical head parts etc. By throwing yourself this test right, what remains to be tested is the communication with a PC, I would try to connect it to another PC if you have the possibility and see if the fault is the same if that is the case, something is wrong in the logic of the printer, if something is wrong in the drivers