⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Printers

orange laser light hp 1006

julachoclodo

hace 6 años

hello I change the filimina of the hp 1006, and disarm three times, control and everything is well placed, when I want to try it, the hp turns on and remains to print, when I send to print it takes the signal ready to print and lights orange, and there are two documents left in the print queue? could you help me?

Comentar



eltenico

614

hace 6 años



hace 6 años

Did you connect all the paper sensor cables to the board well? Are all the sensors in good condition? you have to move them and see that they are physically well and that they return to their resting position. is what I would ask at this stage

Comentar

julachoclodo

hace 6 años

hello those sensors are down? because the only thing I take out is the fuser, I changed the filimina, before the printer printed but I cushioned the sheet by the broken filimina, then I bought the filimina that came to me without the special grease and placed it, in the fuser everything enters one way, impossible to confuse me in assembling the fuser



Responder

eltenico

614

hace 6 años

not to assemble the fuser but when I take it out I think I don't remember that model precisely you also have to disconnect or remove the cables that go to the tonner sensors and papers are mobile plastic pieces that interrupt the passage of the lus between two black turrets



Responder