As it is new I did not put the continuous system that I already have because to install it it would be necessary to bore the side. . . and to top it off the H. . . . . that they sell you the system but they no longer provide you with the bearings or plugs, which they could also have used to recharge. Then I reloaded the empty cartridges but the original tape covering the holes did not stick. I tried using packing tape, paper tape, insulating tape, but they throw ink on top and bottom. I am from Prov. Of Bs. As. Near the capital. YOU WOULD NEED TO GET THE BUSHINGS AND PLUGS OR IN ITS DEFINITION A TAPE THAT ADHESES WELL TO THE LOIN OF THE CARTRIDGE THANK YOU VERY MUCH ALREADY.

Hello! so you comment if you did the ink refill procedure incorrectly, some air bubble may have remained inside the cartridge. The refill process is inserted x ml into the cartridge and while you lift the syringe you suck a little. Above there is no problem left open because you need to have the air inlet.