IMG_20191124_113556.jpg [4.44MB] Good morning,
I live in a neighborhood with poor water service, the pressure drops a lot and sometimes the pipe is cut off and the pipe is filled with air. And then I'm several days to purge the system.
The system is composed of a water tank, a pressurizing pump (with option of bypass in case the light is cut off or fails) and then three drops of water (hot, cold up, cold down) and a drain.
I was reading that some recommendations were to put a vacuum breaker, but I don't know if that is compatible with a pressurizing pump and if it is possible in which section of the circuit it is installed.
From already thank you very much!
Cheers
⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
Sanitary
IMG_20191124_113556.jpg [4.44MB] Good morning,
I live in a neighborhood with poor water service, the pressure drops a lot and sometimes the pipe is cut off and the pipe is filled with air. And then I'm several days to purge the system.
The system is composed of a water tank, a pressurizing pump (with option of bypass in case the light is cut off or fails) and then three drops of water (hot, cold up, cold down) and a drain.
I was reading that some recommendations were to put a vacuum breaker, but I don't know if that is compatible with a pressurizing pump and if it is possible in which section of the circuit it is installed.
From already thank you very much!
Cheers
Air pipes
hace 5 años
hace 5 años
IMG_20191124_113556.jpg [4.44MB] Good morning,
I live in a neighborhood with poor water service, the pressure drops a lot and sometimes the pipe is cut off and the pipe is filled with air. And then I'm several days to purge the system.
The system is composed of a water tank, a pressurizing pump (with option of bypass in case the light is cut off or fails) and then three drops of water (hot, cold up, cold down) and a drain.
I was reading that some recommendations were to put a vacuum breaker, but I don't know if that is compatible with a pressurizing pump and if it is possible in which section of the circuit it is installed.
From already thank you very much!
Cheers
138.835
hace 5 años
hace 5 años
Hi. As the friend Heating told you if possible. You must place a tea immediately after the general stopcock (the one that leaves the tank). The output is apparently 1 "so you should place a 1" with central reduction to 1/2 ". In this reduction you must place a spout of that measure upwards that exceeds the level of filling of the tank. In its tip are two elbows of 90º like so that it is looking down and no dirt enters the tank.If you do not realize how to do it I can edit your photo by showing you.I leave you a photo of a tank that we made with the breaker and its elbows.
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off
Yamil Alarcón
$ 29 USD
$ 12 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad