Good evening friends: I have a Scottish shower on a 2 floor, the hot water tank on the 1 floor and the tank that provides water on the roof of the 2 floor ..... Question: Do not have hot water pressure or cold water, check the monocommand of the vanitory and it is also the same ... what could it be? Will it be missing a pump for water pressure ... and if so ... where do I put it? I'm learning about plumbing ... and well ... I don't know much ... I need guidance and help ... Thanks guys!!! PD: the pipe is 5 years old.

Hi Pipo! First of all you would have to look at the water connections of the appliance, that it does not have metal bushings mixed with what should be plastic pipe, if it had all plastic, it also disassembles the connection and controls that it does not have a tartar seal reducing the inlet diameter / output, and since you are with a bucket you control the amount of liters per minute in the mouth of the artifact. Tmb would check stopcocks by closing them and checking that the closing does not feel like sand inside. Based on the amount you see here you will be able to determine if the problem is there or pipe inside. Comment how it went.

I had a common pump (water transfer) and not a prezurisadora ... put on a Rowal tango 14 and the shower was running ... thanks to all.