✅ Regular automatic / floating electric tank.

Good! I have a question to answer two cases: I want to regulate two automatic / floating electric float + cotrapeso, one in a tank and another in an upper tank. At this moment what is on is Viyilant Brand IT model. For the tank, I want it to fill as much as possible, up to about 10 cm below the level of the pipe that enters the tank, and start as soon as possible when the water level begins to drop ... to optimize, it should be when the tank already consumed an amount equal to the capacity of the tank ... In the cistern, I want you to enable the sending of water when the level is high, and interrupt it when you have about 10 cm (to avoid sucking "dirt"). Now, I know that I should play with the location of the counterweight. In the case of the Viyilant, it must be at least 20 cm from the float. The question I have is more than anything about how the system reacts to move away or close to the float counterweight, and how much should I regulate the "cable" of the whole set, that is, assuming an X separation between counterweight and floating, what happens if I lengthen or shorten the length, moving the whole set? I will thank you for everything you can illustrate! Greetings and thanks!

Hi. The submersible automatic as they told you, is not as accurate nor as easy to regulate as those of two buoys, although it is usually more efficient and durable if you place one of good quality. The automatic tank tank, at its lowest point, must fall completely (it must be upright hanging from the cable) about 10 cm before reaching the pipe where the pump sucks water. The distance between the counterweight and the buoy should be as recommended by the manufacturer, some twenty another 30 cm. With the tank almost empty it is easier to make this regulation. Hang the entire assembly to the position mentioned above. Then the cable must be tied at the upper edge of the tank (if it is not bored, a small perforation must be done) it is not convenient to do it in the lid, since it makes it difficult to observe and disassemble it. For the elevated, it is a bit more complicated. Respecting also the distance between the buoy and the counterweight, it is necessary to look for the desired upper point of cut. Once located, the cable should be tied as close to the upper edge as possible, without altering the previous distance. That will allow it to start when one third of the water in the tank is missing. Unfortunately, some bring a counterweight that is too light and the automatic can be lifted together with the counterweight, causing the container to overflow. In some cases to correct that fault I have had to add a small additional weight. Important: place both devices away from the water jet that comes from the pump and tmbn. of the mechanical float that brings running water. Regards.

¡Aprende a reparar con estos cursos YoReparo!

Regular automatic / floating electric tank.

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

Curso Reparación de Fuentes Conmutadas de PC y Equipos Electrónicos

Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off

Curso Refrigeración Comercial Aplicado a Diagnóstico y Reparación