⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
Sanitary
Toilet flexible exploded.
hace 6 años
hace 6 años
While bathing my pear in the kitchen I felt an explosion and saw that the bathroom was very steamy ...... I closed the water and gas tap
then I went to the bathroom and saw that the flexible had burst ...
Someone could tell me what could have happened ..... so that it doesn't happen again.
19.266
hace 6 años
hace 6 años
Hi ; Surely you have direct water, the non-short water heater generates overtemperature raising pressure and not being able to go back through the cold water pipe burst the weakest flexible, check the water heater greetings
295
hace 6 años
hace 6 años
One of 3:
-Or a lot of pressure on the line, more than 5 bars, whether you have a direct street line or by means of a pressure motor you must have a pressure lower than 5 bars, the ideal is 2 bars.
- Or a long time of not changing the water flexos and they were spoiled by the time.
-O manufacturing defect.
hace 6 años
Sorry rl flexible is the bidet. ...
Check and I saw that the heater does not cut
So I guess it must be the diaphragm
hace 6 años
Here in Mexico there is a problem with some types of Boiler of the so-called low flow, since the drive system is by magnetic sensor and when the inner magnet breaks down the pieces anchor the actuator in a position that could be the ignition, I It has touched to change pvc pipes that are damaged by the over temperature generated by not turning off
5.181
hace 6 años
hace 6 años
Hello
A lot of steam in the bathroom?
The flexible toilet should be cold water, so there should be no steam to burst the flexible.
If the bidet (hot water) is flexible, maybe ... just maybe, the temperature of the water heater or hot water tank is excessive.
Replace with flexible meshes and lower hot water temperature.
Regards
138.835
hace 6 años
hace 6 años
Hi. The flexible was plastic? They are not suitable for high temperatures. This occurs with the use of hot water tank. You must replace it with another of chromed bronze that does not decrease the flow rate like plastics or rubber meshes. Maybe you should change them all to avoid future damage and increase the flow. Regards
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
Curso Refrigeración Comercial Aplicado a Diagnóstico y Reparación
Ing. Georga Melgarejo
$ 40 USD
$ 13 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad