Good evening I write to the community of I repair to see if they can help me and advise. I am from Venezuela I have a problem with the electric gate of my house, which damaged the card that controls the activation of the engine to control the rotation of the engine and thus close and April the gate, it burned the triac, it was changed , only that component, the resistance was not changed but they are bursting and its value is not appreciated and I do not have the diagram of said card to know how much the resistance was damaged. I would like to know if you can help me get the electrical plane or electronic of said card. The card is an MC-TRIAC-LT CODIPLUG Or how can I do so that the 220vac single phase motor is activated by means of pushbuttons and the logic of rotation to the left or right is to say open and close the gate by means of contactors or relay and stop by Micro Switch. I am empirical I don't know how to read or interpret plans, if you can help me through drawings with lines of lines joining the components, I thank you

The cm triac is a card for magnetic limit switches, the function of the triac is the instantaneous braking of the motor, the resistance used under the fuse is the most damaged, I do not remember how much it is, but to make it work you can replace it with a cable filament (although it is not the most advisable), particularly I recommend you buy another card do not continue repairing it because they do not look good, to control the engine you can use a special key selector for that, but I would lose the logic since you would not use the card, if you want to use the card, it has two terminals, the power and the accessories, in the accessories you are going to wire 1 and 2 and every time you put the tip of those two cables you drive the motor (you can use any bell type button) and it will work as if you were using the remote control Cheers

20180708_074135.jpg [1.77MB] 20180708_074743.jpg [1.54MB] 20180708_075035.jpg [1.63MB] 20180708_075050 .jpg [1.42mb] how can I make the 220vac single-phase motor activated by means of pins and the logic of turning left or right, that is to say, open and close the gate by means of of contactors or relay and stop by Micro Switch here are the pictures of the single phase 220vac motor and the switches so that you can help me to carry out the control logic with the contactors and pushbuttons. since the card is damaged The card turns on the LEDs indicating when you close or open the gate but the engine is not activated to move the gate, I already tested the engine without the card and if it activates and turns in both directions