Good afternoon, I have a whirlpool lacker 17 kg 7MWTW1702 This labadora does not wash or spin spin. I got into programming and I wanted to reset it which doesn't leave me because of the fault. Then I went into failure mode and it marks me F7-E6 and F7-E5. For the 1st. First of all, check the coils and mark me 5 ohms on each coil and 9 between the two coils. It does not mark me on land .... For the 2nd. Failure to clean the mechanism and lubricate it, remove the actuator and it is wet which will clean and test it and if the mechanism works although I manage to stop it by hand applying a little force. Check the function of the takometer and it marks me well with the machine in tako test mode. Mount everything and the fault persists the same .... cave to mention that when doing the test in manual mode .. I activate the clutch and the actuator works by clipping and disengaging 3 times and makes a turn the engine and stops, repeating this only and does not start . Another point is that the labadora was throwing water. I would thank you in advance for your problem.