Whirlpool washing machine model 8MWTW1915CH0
Hi Felix1966
This error refers to the MAIN CONTROL DESINCRONIZATION, which indicates that one of the controls is damaged,
To identify which of the controls is damaged:
1- Enter the SERVICES DIAGNOSTIC mode, all LEDs are on
2-Then turn the knob clockwise, until only the RINSE AND EXPRESS LEDs turn on
3- Press START, all the LEDs light up
4- Press START again, the LEDs turn off
5- We start by turning the controls one by one
If turning the pads do not turn on and off the corresponding LEDs, it is that the control is bad
Hi friend Jorge. I did the test you told me and everything is fine, I turn the knob and the LEDs that are off turn on and those that turn off go off, that makes it very good, I tell you that the client has almost the same and change the cards Small ones that have sides and worked very well. I think it is the main one but its high cost makes me hesitate to buy it. I do not want to spend a lot of money and that is not the problem, although I think it is. What else can I try ??? Thanks for comment.
Hi, Felix
What I would do in this case
1-Check the connectors, clean each one and clean contact or with isopropyl alcohol.
2-Check the harness, take each of the cables that leave the main card J10, and check continuity, also clean this connector.
3- I perform calibration mode
Regards
okay
We wait for an answer to continue with the help, or if it is possible to reach a happy ending, close the question to file.
Regards
Buddy, do you know what's weird? I put it to work and it does the whole cycle very well, water enters, drips the water, but it doesn't spin, that's what happens to it. I put it directly to centrifuge, turns around at the beginning and then stops but continues to drip the water but does not squeeze, after a while it gives the alarm as the clothes are ready.
Hi, Felix
Is it easy for you, send me a picture of the board of your washing machine?
Thank you
It must be for the size, you must open it in Paint and modify the size of the photo, this way you can send it
Thank you very much to both colleagues for helping me. I have always said that the failures they give in the service mode are sometimes not correct, once again I have had to experience it. The truth was not the main card so I hesitated to change it. Now I know that we can help another person with the same fault. Thanks from Guayaquil - Ecuador
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
