⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
Whirlpool
Whirlpool wfe61a
hace 5 años
hace 5 años
Good day I have a new unit washing machine 9 months of use preceded me the problem that when programming any point. And to give Play to turn on the board marks me flashing three celestial lights and everything remains without turning on the door joke pump. Water inlet all ok continue with the fault
23.662
hace 5 años
hace 5 años
Hello, as you are well told, the error refers to the heating resistance, but it is not only that, it is a whole group linked to it, so I suggest that you control wiring in good condition and especially the sulfation-free connectors, both peripheral side as electronic board side linked to heating resistance. Regards
hace 5 años
Hello, if you excuse me, I didn't put the times ... in the previous msg when I put the program on, it flashes three times
hace 5 años
Hi, I put the program on and when I press on the ignition, I get three times the light that could be
hace 5 años
Hi, the resistance has the 220 volt input and in the middle there is a card that I calculate is the thermostat if I disconnect the error it would have to go or I have to replace the complete resistance
95.432
hace 5 años
Dear, this machine can not bridge anything or disconcert either, as the board takes it as an error and warns you of this by flashing the LEDs or display. Normally the resistance has the two power cables at the ends. In the middle is the earth and between the earth and one end is the PTC or temperature sensor. Salute
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad