I got a samsung wa19w9 washer, it turns out that the rats ate much of the electrical wiring and someone did not know who (if the owner or some technician) tried to mend the wiring and when testing the operation did not work, this was mentioned to me by the owner, so come to me and effectively to put it to work rather just plug it in spend a few seconds and the display first shows the code 0E and then 1E and it is smelled that the drain pump starts working, as far as it goes this error is given by the pressure switch, look for a pressure switch that I have and I know that it is good so I put it on but it continues with the same error commands (0E AND 1E), on the electronic card. I do not know if that was the case or if the one who tried to repair the wiring improvised and put a connector that was not there, I say this because a connector on the card is 6 pins and the wiring connector has only 5 pins and this connector is precisely The one who is going to give the pressure switch so that is where I have my doubts and that is that I do not have the diagram to see the connections and I have not been able to find it on the internet, how to know if it is the card that is damaged or is the connector is damaged since this improvised connector also has 5 cables and those that arrive are only 4 that I can do more. Thanks in advance and I hope someone can help me. [img] https://adjuntos.yoreparo.com/imagen_post/0004/65/f1f85d17ef762c5acb2176bbf0f84f2d8g4g33f2g8g4f33f2f8g4f4g4f4g4f4g4f4g4f4g4f4g4f33f

sorry but I have been reviewing the diagram and proving I already found a part of the fault, it turns out that the connector that mentioned them was not going there but anyway it served me, with the diagram and with the color of the cables I connected them as they should be connected and no longer send me the error commands 0E and 1E I can already enter the rinse and spin wash mode, but now it only remains that when plugged into the outlet it smells that the water filling bulb starts working, I also observe that also the drain engine is energized and the arm is collected, so when I put it to wash the drain engine is already activated and only moves the agitator on one side since the drain engine is activated when trying to move the other side the agitator moves with everything and tub as if it were spinning, and now that it could be, maybe it will have some badly connected cable or it will be on the electronic card, because I saw in a youtube video that in other models of samsung washing machine you can have in c Ort a triac that controls the water inlet pump and the drain motor (triac that is not in sight), could you help me now with this.