⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Samsung

Wa12n9 error e was blocked when spinning

gonzalo rodrigueztecnico

9.229

hace 6 años

Samsung wa12n9 washer was blocked when spinning. If you wash testing was performed by bridging switch and door switch, error and continuous, suspicion of pressure switch. But I don't rule it out on trial display does not show 1st letter or code number only lock and mark e someone has had similar failure

Comentar

gonzalo rodrigueztecnico

9.229

hace 6 años

I'm going to buy pressure switch and change it, I hope it's not drainmotor the damaged one



Responder

gonzalo rodrigueztecnico

9.229

hace 6 años

They sold me pressure switch nt da20. They think it works instead of dls17 .. They tell me that it is compatible



Responder

gonzalo rodrigueztecnico

9.229

hace 6 años

Failure E was due to pressure switch error, da20 pressure switch was installed and it already works
Thanks Fermin 007



Responder

Fermin 007

57.307

hace 6 años

Give nothing colleague Gonzalo, the merit is yours, you risked changing pressure switch, the good thing was that I work, congratulations colleague, greetings



Responder

elmeneao

115

hace 6 años

Wuenas! check the engine! Rate and comment! Regards!

Comentar

gonzalo rodrigueztecnico

9.229

hace 6 años

The engine works perfect. It works ok during washing that is to the right and left. Tina is empty so she should work. Door switch and unbalance are bridged
The strange thing is that error only marks E in the second box. It is not oe. Ie From. Be etc. only E



Responder

gonzalo rodrigueztecnico

9.229

hace 6 años

The dls17 pressure switch is not easy to get



Responder



Fermin 007

57.307

hace 6 años



hace 6 años

Good morning Gonzalo You say that nothing else appears the E? No letter or number accompanies it? Look I went through something similar and they were cold welds on the card, a question drains the tub and then does the motor Drian not enter? Have you checked the Drian engine by connecting it directly? Remember that when you finish washing, it is then activated, then the drian motor and then starts to throw the water, the pump is related to the Drian motor, that is, they are connected together, if you have suspicions of the drian motor, check it by connecting it directly, and so see if the washer already works in centrifuge, greetings

Comentar