My Philco DR PH60 tumble dryer makes noise when turning
Good afternoon Guillermo, I told you that I took off the back cover and I saw the belt, the take off of the motor shaft and at first glance you see that the engine turns normal without noise, turn the drum and it shows that it has a bit of play since I move the drum from the mouth and it shows a game, it is not much but as I do not know them, I do not know if it is normal or that game is what makes noise when turning
If the drum is the problem, how do you get it out to see the bearings that center it?
Hello, I had some suspicion that your wheelmakers would be bad and you confirm it, you have to carry out a disarmament of the equipment to perform this job included. Regards
Hi Juan, can you give me a hand helping me with information about disarmament?
So far I removed the back cover and removed the belt from the motor shaft.
Does the drum calculate its dimensions up?
If it comes out I have to disassemble the front, I see that the lid has a block and a bellows q if I run the rubber you see screws,
a screw is also visible behind
Any information on disarmament will be very acute to me Juan and thank you very much for the data already provided
Friend. If the cabinet is "closed" there is no choice but to remove the machine from above. See if you can upload images so we help you better. Regards
Hello, I mean that you raise images of the equipment so we help you better, anyway as I had said you would have to take the whole machine out of the cabinet to make the replacement, as much information is not there of this equipment and spare parts are very depleted First find out if he gets the star, catch and wheel. Regards
And disassemble everything, take out the bearing support and then leave the bearing alone, it is incredible that the bearing has 22mm of outer diameter 8 of inner diameter and 7 of thickness, I relate it to the drum of almost 60 cm in diameter and it seems very flimsy?
Q shelf life can be saved unless you dry very little clothes for every drying
Hello, if the equipment is dryers, it would only be within the parameters used, it does not stop calling attention to the measures of this ruleman, since the closest would be 6304 or 6005 but the measures differ slightly. Try to get SKF since the alternatives are of little useful life, go with the sample, as for the duration it is as you say few garments give an optimal drying performance. Regards
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
