⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Mabe

washing machine mabe lm11832pbas when programming to wash tour and sto

tecnic_frank_01

hace 5 años

it is a mabe lma11832pbas washer, I changed the pork botava water seal, it was assembled by her and she was sinking, but when I program it to wash, it turns once and stops, the wash light flashes but I give the start button or wash and turn every You see, I give the button check the engine sensor and this is a good help.

Comentar

Fermin 007

57.307

hace 5 años

And how do you know the sensor is good? Have you tried it in another washing machine? in short, according to the fault presented by the washing machine is the damaged weight sensor, check that the sensor arrives 12vdc, if it arrives, change it again to the weight sensor, greetings

Comentar

tecnic_frank_01

hace 5 años

thanks for the help to solve the fault was the resistance of 820 homios k goes in the plakita near the transistor weight sensor k was rusty and not good contact I put another and ready sometimes the transistor is good and what is damaged is the resistance thank you very much for your contributions



Responder



Felix Romero

hace 5 años



hace 5 años

com say colleagues how do you know it's good This is usually the failure to constantly throw water through the already damaged gaskets tend to corrode from tartar and therefore decompose as a centrifugal water pump weight sensor and even the engine if you changed gaskets you should have failed to change bearing seals pulley both above and below the tub so that you don't leak again and damage the components

Comentar