I have a Mabe brand LMA1110LME washing machine when it starts to wash sometimes it starts to spin once and the manual LED starts to flash and the wash LED stays on but does nothing more and I have to disconnect it to turn it on again , other times it fills and starts turning the tub and the blade to one side as if it were spinning but does not turn on the drain pump. When I put it in a rinse or spin it only pauses and if I put it in an extra squeeze, the manual led flashes again and the spin one remains fixed. already check the door sensor and the electronic pressure switch and the transmission selenoid but the latter does not reach current. Thanks in advance.

good night. Your washing machine at all times that you are given the order to squeeze should turn on the water pump. you should check that the 110 volts or 220 are arriving according to your area. If that happens then the pump does not work but if there is no current and because of the fault that the selenoid of the transmission does not arrive, I would be inclined to think that it is your electronic card that is not working correctly. luck.