Greetings experts from YoReparo, I have a 19 kilos chaca chaca washing machine that only turns on one side searching the net I found that the problem is in the Taimer, I continued to change it and nothing remained the same I went to the capacitor I bought another one of equal capacity and nothing was the same I kept looking and I found that I could try a refrigerator capacitor and I put it on and suddenly the happiness appeared because it worked for both sides, but the same lasted little since when putting it to work with load it returned to If I walk the same way, to do the same thing for a single side, turn, the question for YoReparo teachers has to get a capacitor with more capacity or what do I do to make the chaca chaca work. I comment that I put the same taimer that he brought and with the same job with the refrigerator capacitor but no load and with load he returned to the roads. Thanks in advance for the support ... Note: annex photos ..

Greetings benign silva. Usually when this fault occurs, what happens is that the electronic component called triac is damaged in the direction of rotation where the motor rotor does not rotate. By replacing it as long as there is no other damage to the corresponding card, the engine will do its job. It is recommended that an electronic technician or failing a TV technician carry out this review and replace the damage present in the referred card. Keep in mind that it is very important to respect the value in microfarads that the original capacitor shows in its legend. Placing another capacitor whose value is below the original can result in irreversible damage to the motor and goodbye light that you turned off. There have been cases where the capacitor internally suffers damage in one direction and hence the motor does not respond accordingly. However, it is feasible for the motor to have a problem and to rule it out and if you have a tester, measure continuity between each pair of cables that feed the motor and that are three: one in black that represents the neutral, another in white which represents in a counterclockwise direction and with a phase signal, and finally the yellow wire that represents the clockwise rotation and which also carries the phase signal. When the motor connector is disconnected and when measuring between every two pins of the three involved with the motor, you should find that two readings should be equal while the third reading will be the sum of the two equal. If that is not true, there are problems with the motor winding and you will have to have it rewound or replaced. Thanks and regards.