M@uro

12

hace 5 años

Thank you very much! I look forward to your comment to resolve it! Regards Luis38

luis38

95.432

hace 5 años

Dear, I have two such plates, but both have THT type triac. One carries the ACST2 and the other carries the BTA08. The ACST2, comes in both encapsulated. regards

M@uro

12

hace 5 años

Look for the datasheet of these two Triac, but there are differences between them, both come in encapsulated Dpack that would be surface mounted, called an importer of components and tells me that it does not have them in surface, the acst2 is 2 amps, the bta08 It is 8 amperes, now I'm going to have to find a way to adapt any of these to the board, do you have any idea if it influences that you have inverted the Triac terminals? The one that is door "G" already identifies it, but with the others I am in doubt, there is a clue that is common to all Triac, which I imagine will be the "COM" terminal and the other to the connector

M@uro

12

hace 5 años

Luis from now I want to thank you for your interest in my problem, I was very helpful, my profile is my email address, then write me so I have your contact! And thanks again!

M@uro

12

hace 5 años

Do not even try to change for the proposed triacs, remove the protective gel of the TR5 and TR4 and indicate that they are the ACS1086S (control 0.8 Amps), seeing the datasheet indicates that it is a triac but has something else associated (I do not know what is) inside the encapsulation, then based on controlling 2 amps I found the ACS120, it matches me in size (DPACK) and on the board it is connected in the same way as the ACS1086S, with a parallel capacitor and a series resistance to micro that controls it, looking for a replacement (which I didn't find) I find myself looking for the component even

M@uro

12

hace 5 años

Hi everyone!!! finally solve them, the component in question is the ACS120-7SB in the package it carries a triak with another component, it has a cost of approximately $ 102 pesos, I could get it at a distributor called Dicomse: http: //www.dicomse .com.ar
I changed it and walked out !!!
Greetings to all and many thanks to those who contributed their knowledge to help me
:)

luis38

95.432

hace 5 años

Dear, we appreciate your input, as this component is the cause of the service exit of many plates. I think this triac also goes on the plates of Samsung washing machines. regards

M@uro

12

hace 5 años

Good day,! From what I read if !!, Samsung washing machine and some refrigerator plate to control the forcer, I took it out by deduction, remove the protective gel and look for the value of TR 4 and 5, then look within the same family one more powerful knowing that it controlled 2 amps and I found the component, I was resigned to changing the board, more so that my client had been scammed, so it took a while but the problem is solved!