Automatic washing machine luxury link ewt10a pulls the water
Check everything the colleague tells you. I only add one more point. If you have a piece of hose added that is not the original of the washing machine, remove it.
Thank you very much for your suggestions. The corrugated discharge hose is at the original height that came from the factory, that is, it comes from below and rises to that height approx. Fastened with seal and from there it goes down towards the end. But if I have added an extension of corrugated hose to the end of this more than 1 Mt approx and another 3 meters more than 1 "irrigation hose so that it finally reaches the drain, in addition I also have extension of the water supply hose, no I know which of the two means to remove it. It should be noted again that it only discharges the water once it is used ...
The water discharge. That is the one that causes inconvenience when it has aggregates. It happens as when one passes fuel from a drum to the gasoline tank. And although the drum is supported on the roof of the car, the fuel passes the same as a result of suction. That is example.del.because you don't have to have aggregates
Dear, what the colleague provides (greetings) is what happens in most events, the aggregates and more so that the diameter decreases makes the water is not in the washing machine, this happened with several washing machines of customers who had done this added to reach the drain. Regards
Sorry for the delay in responding. Effectively remove the extension from the drain hose and it was the solution. I also insist that the water did not pass from the load to the discharge but when it should reach a high water level. Remove the extension and instead place an intermediate tank for drainage and from there just drain to the drain ... holy remedy! Thank you very much for your advice!.
Well, I'm glad you solved it with the help of this useful page, have an excellent day. Regards
Sorry I continued my answer here that I ran out of space above. He said he only throws water if the HIGH water level is selected in any of the programs, but not if the medium or low level is selected. I estimate there will be a high level sensor that for some reason activates also the drain pump.
I will try tomorrow to remove the extension to the corrugated drain hose and commented. The end is not submerged so it is not possible to suck the water.
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
