Good afternoon everyone, I tell you what happened. The washing machine in question was walking and stopped, when I was checking it was off. Disassemble the control panel and the plate was burned in the sector shown in the image. Change the plate but still not on. Anybody could give me some idea of controlling that resistance sector and what should I check? and I defend myself with some electronics stuff. Thank you very much in advance

First of all, do not connect the new board, the fuse may be kemado, the door block, thermo actuator or pump is shorted, the board will return to kemar but first change those components

Dear, before the doubt it is always convenient to change the door and thermo actuator. If you replace one with another, without determining the cause of the problem, you run the risk of damaging it again. Take the same precautions you have in your computer work. Regards

Friend the thermo actuator is colored board and is pressed into a plastic arm attached to the pulley, the door blocker is located under the lid of the washing machine, just below where the piston that locks the door enters, both have confections, look for take photos more than everything of the connection of the blocapuerta to place the new one in the same way, greetings