I set it to 1 and it starts to load water, but it doesn't fill up because it lifts it out (the drain hose is well raised) it's like the pump takes it out.
We place centrifuge and centrifuge
The plate heats and smells
⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
UNICOMMAND 116
My unicommand 116 washer does not turn off at 0
2
hace 6 años
hace 6 años
Hi, I have the washing machine drean unicomman 116 and when plugging it in and at 0, the engine starts.
I set it to 1 and it starts to load water, but it doesn't fill up because it lifts it out (the drain hose is well raised) it's like the pump takes it out.
We place centrifuge and centrifuge
The plate heats and smells
I set it to 1 and it starts to load water, but it doesn't fill up because it lifts it out (the drain hose is well raised) it's like the pump takes it out.
We place centrifuge and centrifuge
The plate heats and smells
23.662
hace 6 años
hace 6 años
Hello, your electronic board is in trouble, but this would only be a consequence and not the cause that could well be the engine that is partially "short" and this affects the electronic board, that a professional tape drive controls it to be corroborating or discarding faults of this, also check that there are no losses by the central axis that could have wetted it. Regards
23.662
hace 6 años
If, as a first step, disconnect the equipment when you do not use it, this causes the voltage spike plate in the network to last and allows it not to be active when the equipment is turned off since it is still receiving power even when switched off and transforming it. Also see that the screen printing of the panel is not broken on the pushbuttons as this can cause moisture to enter and wet the plate by taking it out of service. Regards
23.662
hace 6 años
By the flash it is not possible to be distinguished very well of which triac is the one in trouble, if it raises another image of the whole plate, we will place ourselves better in the problem of this one. Regards
Regards
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off
Yamil Alarcón
$ 29 USD
$ 12 USD
Curso Refrigeración Comercial Aplicado a Diagnóstico y Reparación
Ing. Georga Melgarejo
$ 40 USD
$ 13 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad