Good afternoon . I have problems with a unicomand drean, it turns out that it does not turn on. I had the plate burned. I changed him as I also changed the door block. I put on the new plate and it does not turn on, I checked that tension arrives and it does, I measured continuity in the cables and where it gives me positive. Someone could tell me where I'm looking for the problem. From now I feel grateful. With the people of this group of people I learn day by day.

Hello, they are very basic plates and therefore any inconvenience affects it, first you have to find the problem of why the previous one went out of service and solve it, otherwise these things happen. Could you upload an image of the burned part of the previous plate? Regards

Hello! I have a single-mode drean, it doesn't spin, but all other functions make them normal. when you take the lid off to see the plate, notice that the ceramic resistance 10w6.8knj is very hot, the mains input fuse is not blown. Also make the bridge between pin 2 and 3 of the gate and still without centrifuge. The platelet is observed dark medium on the side of the ceramic resistance mentioned above. I was reading many comments of me repair. Any suggestions? Greetings in advance.