My washing machine turns on the programmer but only 2_3 turns, ...
check the tachometer, the motor that works well because it spins without problems, and when you have to wash it makes a few strong turns but it madass more and does not perform them in a continuous way, it stops until it reaches the function that continues
If it were the programmer, there is a way to fix it or the only solution is to buy a new programmer, since they are very expensive
Hello, at the moment I do not think the programmer is the problem, but the power plate located next to the engine, it could be that it has relay problems or tracks in poor condition. Regards
the power plate is the one that I already changed for a new one ... but I continued with the same problem ... take a hard turn when I turn it on which will translate into two or three turns and then still until I get to the function that follows that gralmemte. is to drain ... the centrifuge does it with a lot of power ... I DON'T KNOW WHAT MORE CAN BE. How would it behave if the programmer did not work ??? because my washing machine if it keeps spinning.
Hello, if I control the engine and the power plate is new, the options are ending and pointing directly to the programmer who is not sending the signal to the board and would behave in this way, still while the micromotor keeps turning. Regards
Hello, is the power plate original or the alternative? If it is the alternative there is the problem, many times they present errors in the operation, proof of making the change where you bought it, greetings.
Thank you all for helping me ... but I keep checking and I don't find the problem: the power board is new original,
the pressure switch works correctly
tachometric coil well connected
hoses cleared of all dirt
centrifuge perfectly .. but ....
DO NOT SPIN CONSTANTLY IN THE WASHING FUNCTION, it only turns and stops until you reach the next function ... it does not turn continuously just to spin ...
help that can be ...
call a technician and you don't know what it can be ... help ..
Hello, if you have a spray contact cleaner, apply it on the motor and plate connectors, in any case I think these can be reversed, if so, do the conversion of connection and see what results you get, if that does not solve and such As I said the programmer is not sending the signal. Regards
