⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Excellent 8.12 Blue G

drean exelent blu 8.12 gives error 7 LED flashes

Renegao66

hace 5 años

Good morning people Unlock the plate to take it out and I don't see how to take out the program control knob to have it checked since it gives 7 blinks error in the LEDs and I don't want to break anything from now thanks

Comentar

juan guillermo caceres

23.662

hace 5 años

Hello, dose the soap more or try to wash without this adhesive and see what results you get, also check the pump that works properly. Regards

Comentar

alturasbal

27.174

hace 5 años

Hello, if you load water and give error 7 the problem may be the pressure switch that does not cut to the required level or the solenoid valve continues to pour water until the error occurs, control those two elements, greetings.

Comentar

Renegao66

hace 5 años

Thank you very much for the help you are giving, reviewed everything you indicated and then commented



Responder



luis38

95.432

hace 5 años



hace 5 años

Dear, this error code may be due to excess foam when centrifuged. Check before going to the board. Regards

Comentar

Renegao66

hace 5 años

Hello Luis, I tell you what makes water load but it does not start in washing, it stays and the LEDs make the 7 blinks stop and it does them again and so ducesivemte



Responder

luis38

95.432

hace 5 años

Dear, if the fault occurs at the beginning of the cycle, check the condition of the drain pump that is not burned or shows signs of winding overheating. If the pump is fine, it may be the triac that energizes the pump that has partial loss of energy. Regards



Responder