This washer was carrying water and when he had to turn the engine he was left doing nothing else
I checked the engine and it was fine so I started to pull down the platelet and when I took it out I found this, my question is, what does it tell me that when I put one on it, a new platelet will happen again?
As a check I checked only the engine and it was fine, it may be something else that causes me this, surely the triac that is seen next to the flash is the engine
⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
Excellent 8.12 Blue G
This washer was carrying water and when he had to turn the engine he was left doing nothing else
I checked the engine and it was fine so I started to pull down the platelet and when I took it out I found this, my question is, what does it tell me that when I put one on it, a new platelet will happen again?
As a check I checked only the engine and it was fine, it may be something else that causes me this, surely the triac that is seen next to the flash is the engine
Drean 8.12p platelet problem
401
hace 6 años
hace 6 años
This washer was carrying water and when he had to turn the engine he was left doing nothing else
I checked the engine and it was fine so I started to pull down the platelet and when I took it out I found this, my question is, what does it tell me that when I put one on it, a new platelet will happen again?
As a check I checked only the engine and it was fine, it may be something else that causes me this, surely the triac that is seen next to the flash is the engine
27.174
hace 6 años
hace 6 años
Hello, that triac corresponds to the pump, replaces the pump before putting a new plate and checks its wiring, also controls the rest of the peripherals, solenoid valves, door block, engine, etc., the motor traic is the one that is mounted on the Aluminum heatsink, regards.
401
hace 6 años
Thank you very much, the pump will take it out and probe it out, walk, but it has play, if you touch the impeller it shows, if you change one to the pump
401
hace 6 años
Thank you very much, I changed the platelet for a national one, also the pump and the cables of this one, everything went well, thank you very much for the data,
The only thing I just told you is that the display also changes it and is not quite right since the numbers do not look good in their entirety, but it is not the issue I wanted to solve, again thank you very much everyone for your comments
23.662
hace 6 años
hace 6 años
Friend, such an important "flashing" is affected the peripheral and ALSO wiring and connectors, replace the pump and try to replace the wiring that appears to be fine but inside some parts must be carbonized. Regards
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off
Yamil Alarcón
$ 29 USD
$ 12 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad