⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Excellent 6.06 Blue G

Drean Exelent Blu 6.06g water charging error

HugoDario
hace 5 años
hace 5 años
I program it in short wash or in eco wash. The same error flashes the LEDs twice. However, if it loads water, it seems that it takes time to load water or if it will be a problem with the plate. The operation is as follows. Start charging, finish charging and rotate the drum normally after doing that washing, drain the water, switch to the second LED, reload water for a short time and turn on the drain pump and charge error by turning on the LEDs twice which means that there is a problem in the water charging system. If in the second wash where you accuse the error, I help you to load water with a bucket (when loading water with a bucket, the loading time is less) by doing this, the error does not skip and your process continues well until the end of the wash. My question is: will the solenoid valves or the platelet be?
luis38
luis38
95.432
hace 5 años
hace 5 años
Dear, change the drain hose and check what happens. It may be that it is badly placed or is sucked so it gives that error after the water change. Regards
HugoDario
hace 5 años

Already change the place and control the height but continue with the same error

Responder
luis38
luis38
95.432
hace 5 años

Dear, then it may be that one of the valves is not letting the water pass correctly and that is why it gives you the error. Regards

Responder
juan guillermo caceres
hace 5 años
hace 5 años
Hello, check the discharge pump, that your filter is not thirsty, both this and the solenoid valves are associated with the pressure switch, check that it is not overheated in its terminals. Regards
gallorojocapacitor
hace 5 años
hace 5 años
greetings to colleagues If it takes a while to load the water, it will send you the error, yes or yes, it may already be, due to your low home water pressure (check it), if this is ok, you should remove the soap dish and clean it, it is clogged
HugoDario
hace 5 años

It is already a complete cleaning of the drain pump and its electrovalvula hoses its hoses and soap dish also clean lung and hose that goes to the pressure switch

Responder
HugoDario
hace 5 años

Without more place to check, I started going back to check everything, check everything and change the drain hose again and apparently it was the cause of the problem

Responder
pintilata
hace 5 años
hace 5 años
Change the solenoid valves one by one .... reverse the cables and you will know if the problem is in the solenoid valve. Regards!!
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.93
(14)

Curso Reparación de Equipos de Audio de Alta Fidelidad

Maximiliano Resch
$ 60 USD
$ 20 USD
4.6
(10)

Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off

Yamil Alarcón
$ 29 USD
$ 12 USD
4.71
(7)

Curso TV OLED y QLED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 29 USD
$ 10 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis