⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Concept 5.05

Burnt plate

Torres74

hace 6 años

Hi, I'm new to the forum ... and in this job of fixing a washing machine ... I ask if you could guide me I have a washer drean 5.05 v1 burned the plate flew the Q3 I change the plate but it only loads water, it washes lavage but does not reload water for the glove and not centrifugal, what I notice is that no platelet signal arrives at the solenoid valve and if I want to centrifuge only a signal does not arrive ... that is the problem I have if you could guide me I appreciate it

Comentar



lusangor

56.366

hace 6 años



hace 6 años

Hello The Q3 drives the pump, the blacapuertas and the thermo actuator. To the solenoid valves, Q1 and Q2, here I think you have the problem, or one of the solenoid valves or cables ..... In the following link, you have more information ...... https://www.yoreparo.com/es/electrodomesticos/lavadoras/preguntas/1343843/solucionado-reemplazo-de-triacs-smd-por-triacs-standar Regards

Comentar

Torres74

hace 6 años

Thanks for the tip ... then I commented that I found



Responder

Torres74

hace 6 años

The solenoid valve goes both must be the plate



Responder

alturasbal

27.174

hace 6 años

Hi, did you put an original plate or copy? If it is a copy there must be the problem, they are not reliable, in addition to putting a new or repaired one, you must check the peripherals and replace if there are any damaged, greetings.

Comentar

Torres74

hace 6 años

It is not the original one ... it is from a drean concep c12 they told me that it was the same ... and check everything and everything is fine except the blockhouse that was broken and I changed it



Responder

Torres74

hace 6 años

Hi guys ... I tell you I'm still with the washing machine, I had the plate checked and it's fine according to the electronic so I don't know what it can have because it controls everything and everything works



Responder

Torres74

hace 6 años

Good guys ... I already solved the washing machine is doing very well, the problem I had is that I changed the block door, confident that it worked because it was new and it was not done I put it directly and walked thanks for your contribution



Responder

Torres74

hace 6 años

Hi guys, I already solved the problem I had, the blocapuerta that changed didn't work for me, I was confident that it was new, I put it straight and it was all right ... thanks for your input



Responder