⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
6306

Lavaurora 6206 does nothing, after changing the bearings

Julio_k915
hace 5 años
hace 5 años
When changing rules, plate was moved, the necessary thing to disconnect Cuba was disconnected after assembling everything connected and nothing: 220V arrive at the plate, block well, do not light the LEDs, NOTHING I forget something? Already check everything please help.
juan guillermo caceres
hace 5 años
hace 5 años
Hi, check the 220 input to the board especially the connectors. regards
luis38
luis38
95.432
hace 5 años
hace 5 años
Dear, if you are sure that 220VAC is entering the board and it is not responding, it is possible that it has been damaged in the handling or a bad connector has been left. regards
Julio_k915
hace 5 años

Dear luis38 check all the connectors, also with a phase detector it gives me like there is phase in the connectors, it catches my attention that LEDs do not walk or at least the wash that is always on. I tell him something after removing the tank I start cleaning the bottom of the washing machine and find a U-cable about 4 cm with the peeled tips (1.5 mm2) as if it were a bridge I know God where I shut up, so I can advise I am grateful for everything.}
July

Responder
luis38
luis38
95.432
hace 5 años

Dear, remember that verifications should be done with a tester. It would be interesting if you can take a photo of the cable in question, to be able to help you better. regards

Responder
Julio_k915
hace 5 años
hace 5 años
Dear Luis for now I send you the photo of the bridge
Julio_k915
hace 5 años

Dear Luis, I don't know how to send you the photo again I will try but this I repair again I still do not handle it.

Responder

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.87
(15)

Curso Diseño de Amplificadores de Máxima Fidelidad

Maximiliano Resch
$ 29 USD
$ 13 USD
4.71
(7)

Curso TV OLED y QLED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 29 USD
$ 10 USD
4.64
(11)

Curso Electrónica para Reparación de Placas

Santiago Cediel
$ 29 USD
$ 11 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis