⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
5115

I turn on and jump the circuit breaker

Miguel Leonardo Flores
hace 5 años
hace 5 años
I contact 5115 and it makes a circuit breaker jump .. I bought it used. Change the drain pump ... and it went well once ... two wires. Any other psible fails? I thank you.
Aljavito
hace 5 años
hace 5 años
The water shower is in the same circuit breaker as the rest of the network? because the circuit breaker must be only for the electric shower, and if you are going to try without the shower, disconnecting the face is enough.
Miguel Leonardo Flores
hace 5 años

Hello .Thanks. Tomorrow I try and comment

Responder
ydd:alualo
ydd:alualo
2.847
hace 5 años

Which electric watering can?

Responder
alturasbal
alturasbal
27.174
hace 5 años
hace 5 años
Hello, with disconnecting a single chip of the resistor is enough, the ground one leaves it connected, then you will have to schedule a cold wash for the washing machine to start, also check the wiring for bare wires by touching the cabinet or a loose connector, Comment the results, greetings.
Miguel Leonardo Flores
hace 5 años

Good evening, everyone. Today, I tried to disconnect the hot water resistance by programming a cold wash and went through the cycle without problems ... determined the cycle centrifuged again and no problem ... tomorrow I will continue with new washes.
Many thanks to the entire forum for your help.

Responder
luis38
luis38
95.432
hace 5 años
hace 5 años
Dear, if the fault occurs when the washing machine is turned on, the door lock may be defective. Remember that the resistance just energizes when the water load is complete. Regards
Miguel Leonardo Flores
hace 5 años

Hello, good data, I will try today and I will discard and comment.Mil thanks

Responder

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.84
(25)

Curso Práctico de Reparación y Bobinado de Motores Eléctricos

Héctor Castiñeira
$ 60 USD
$ 20 USD
4.71
(7)

Curso TV OLED y QLED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 29 USD
$ 10 USD
4.64
(11)

Curso Electrónica para Reparación de Placas

Santiago Cediel
$ 29 USD
$ 11 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis