⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Electronics and Circuits

12v LED lamp for charge controller output

Diegomar
Diegomar
Diegomar
214
hace 5 años
hace 5 años
Hello Goodnight. I have connected a solar panel with a 20 amp regulator and a 7amp 12v alarm battery. I wanted to know if at the output of the regulator I can connect a 12 volt led reflector or any lamp that is 12v Or is any special suitable? I would use a good emergency light. And some that come to the car and connect to the car battery, I don't know if you are useful for me
Comentar
Rogelio Sifuentes
hace 5 años

Respecting the battery's 12v voltage, I don't see a problem, with the 12v lamps too, as long as they are not very powerful so that they do not drain the battery, because at night it would only be discharging when the lamp was turned on.

Responder
servimat1
servimat1
servimat1
138.835
hace 5 años
hace 5 años
Hi. If you could use an LED option it would be much better, for a matter of consumption. If you use a laptop, you can change the lamp as there are direct replacements LED version. regards
Comentar
Diegomar
Diegomar
Diegomar
214
hace 5 años

Thank you very much servimat! There I uploaded photo of the regulator that I have. It has the icon of a lamp that supposedly throws 12v. Can I then connect a 12v reflector there too?

Responder
servimat1
servimat1
servimat1
138.835
hace 5 años

Yes, there would be no problems. You just have to check the available or recommended power delivered by that connector in your manual. I keep insisting. If you can place LED versions you will have much less consumption and more light. regards

Responder
Diegomar
Diegomar
Diegomar
214
hace 5 años

Thank you very much Servimat, there I got some lamps that were left over from an emergency solar kit, but the kit said that I had a 6v 2 battery, I can put these lamps to this regulator that has 12v output or it is likely that they will burn ? = I upload image if you want to see them

Responder
servimat1
servimat1
servimat1
138.835
hace 5 años

As I said in your other query, you must "adapt" to 12 volts. If they are 6 and you connect them to 12 they will burn. regards

Responder
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.84
(25)

Curso Práctico de Reparación y Bobinado de Motores Eléctricos
Héctor Castiñeira
$ 60 USD
$ 20 USD
COMPRAR
4.6
(10)

Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off
Yamil Alarcón
$ 29 USD
$ 12 USD
COMPRAR
4.71
(7)

Curso TV OLED y QLED con el Ing. Picerno
Ing. Alberto H. Picerno
$ 29 USD
$ 10 USD
COMPRAR
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis