How to use PICKIT 3
Thank you dear, I found my problem, what happens is that I am using a ZIF socket, the problem was in the configuration of the jampers ... and when deploying the tab in family of controllers I think only the new ones appear, since even recognizing me the 16f628a is not yet on the list ...
Thanks for your help friend.
Greetings and success
Dear, let's see if you can help me to conclude with this, I get to record the pic, but something is not right, since riding the protoboard does not work as it should, I am trying to do something basic with LEDs that are well protected, but not in protoboard, I don't know if I have to configure something additional for the use of the glass ... or I don't know.
Thanks in advance for the help provided.
regards. The pic16f628 has the option of internal RC a project with LEDs does not strictly require a glass, but if it is microcode basic, at the beginning write the line: DEFINE OSC 4, the 4 corresponds to the oscillator MHZ puts there is the value of the oscillator (1 , 2, 4, 8, 16, 20). or does not put any line and will be internal RC by default.
the other is to remember to put a resistor to the MCL pin, so that the pic works, it comes from 5v to that pin you can use 10k.
Thanks for the estimated help, my problem was not the pickit, but the module was riding the pic, I had a series of jumpers that I had to configure according to the pic I wanted to program ... I learned to use it correctly, and I started using it burn to full ... once again thanks for the help.
Greetings . You must put the jumpers as indicated for each pic and also position the pic in the specific part of the socket so that it can be detected.
for 16f, I use it in my case, J1 in B, J2 of 2-3 and J3 of 2-3.
also when placing the pickit3 the last terminal is empty since the socket has only 5 pins. ( At least in my case ) .
Yes, thank you very much! I observed in detail that on the same plate it specifies you how to place them and how to put the jumpers: D only that in a hurry I did not look carefully.
Apart there was a legend that said pic 16f then I placed it there, but there it was not: / haha, it was in gift of said DIP 14/16/20 or something like that (which refers to the number of pins that the pic has).
Greetings and thanks!
¡Aprende a reparar con estos cursos YoReparo!
Curso Refrigeración Comercial Aplicado a Diagnóstico y Reparación
