[img] https://adjuntos.yoreparo.com/imagen_post/0004/773e9797aaaaaaaaaa img] Hi. I have an Atomlux 2020 and since my last use does not turn on the Led, (if I see that it loads correctly).
Is there any way to verify the proper functioning of the LED strip to discard it? Do not mark driving in any way, should it be measured as a normal led?
Thanks for your comments.
Daniel
⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
Emergency lights
[img] https://adjuntos.yoreparo.com/imagen_post/0004/773e9797aaaaaaaaaa img] Hi. I have an Atomlux 2020 and since my last use does not turn on the Led, (if I see that it loads correctly).
Is there any way to verify the proper functioning of the LED strip to discard it? Do not mark driving in any way, should it be measured as a normal led?
Thanks for your comments.
Daniel
Atomlux mod 2020 does not turn on Leds.
2
hace 5 años
hace 5 años
[img] https://adjuntos.yoreparo.com/imagen_post/0004/773e9797aaaaaaaaaa img] Hi. I have an Atomlux 2020 and since my last use does not turn on the Led, (if I see that it loads correctly).
Is there any way to verify the proper functioning of the LED strip to discard it? Do not mark driving in any way, should it be measured as a normal led?
Thanks for your comments.
Daniel
hace 5 años
If you bridge the Emitter and collector pins of the largest flat capsule transistor that is near the R12, the LEDs must light up. If they are good.
This transistor acts as a power switch for the LEDs that are plugged into the CN4 connector.
5.181
hace 5 años
hace 5 años
Hi
You have to check if the current between positive and negative of the board (when unplugged) comes out that feeds the LED strip, if it does not come out, it may be a problem in the relay of the board (this transfers the battery to the luminaire)
If it goes out; Then you have to control the luminaire that usually (depending on how many LEDs are) these would be connected in series and in parallel.
regards
hace 5 años
hace 5 años
Friend, I hope you help him solve the problem. Can you tell me the value and how is the r2 of this plate that flew away and I can't see in your photo?
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
Curso Tecnología Inverter - Fabricación de probadores y herramientas
Yamil Alarcón
$ 240 USD
$ 40 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad