⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Computers

PC starts x 2 seconds and stops.

Benceno
hace 5 años
hace 5 años
Hi. Overnight the PC stopped working. I comment only what I left connected. Mobo Asus rog supreme FX Socket 942 AMD Phenom II CoolerMaster extreme pw plus 700w Cabinet With this configuration, it starts 1 time for 2 seconds and turns off, if I try again it does not turn on, leaving the START, RESET and OC mother buttons on. I was taking out of a 1 component and always testing and obtaining the same result, all the coolers of the gabo, the micro fan, the Mobo lights and all that only x 2 sec. Already remove the extra 4-pin connector and the same result just now. I don't have another PC to test the source, I would have to take it out and take it to measure. I would appreciate any suggestions. Thank you.
1979.
1979.
805
hace 5 años

But now the PC started?

Responder
jochu73
jochu73
31.275
hace 5 años
hace 5 años
That is a short signal, check the mother's and fountain's mosfet and capacitors.
Benceno
hace 5 años

Thank you for your response and for your time Jochu73, I don't have a multimeter and neither the knowledge. I will try to remove the mobo from the cabinet x the doubts that the short is there. Thank you.

Responder
Benceno
hace 5 años

Thank you, it was a capacitor burned at the source.

Responder
psico10
psico10
460
hace 5 años
hace 5 años
Can you enter without it shutting down, to the BIOS? can you start in failsafe mode?
Benceno
hace 5 años

Thanks for your answer and for your time, no, it doesn't load the Bios in 2 seconds.

Responder
Carlos Salas
hace 5 años
hace 5 años
Usually the beep indicates RAM memory failure, you could start by trying another one, ask, did you overclock? it could be bios fault take out the battery 5 min, replace it and try
Benceno
hace 5 años

Thank you for your response and for your time. Charles. No pita, only did it once when reading disconnect the extra 4-pin connector and the test was with empty memory banks. But I will try) from the stack. M Thank you.

Responder
1979.
1979.
805
hace 5 años
hace 5 años
Hi how are you, try doing this. First, before touching the motherboar, touch the cabinet sometimes, the metal, thus preventing static. Remove the battery for a few seconds, then leave it again as it was. Then before loading Windows, I went to the BIOS and selected the option to LOAD OPTIMIZED DEFAULTS. This causes the factory BIOS settings to load. To enter the bios you have to press the Delete key when you turn on the PC, in some BIOS F1 or F2 is pressed, but even if you choose to delete, the same BIOS will tell you if you have to press another key. While on the BIOS screen, look for and select the LOAD OPTIMIZED DEFAULTS option. Save the echo change in the BIOS and restart the PC. I suggest you change the battery for a new one. If it didn't work, and the motherboar emits pititos sounds, mention it, since those sounds are error codes, and each sequence means one thing. Regards, David
Benceno
hace 5 años

Thanks for your answer and for your time, hello, no, it doesn't emit beeps, it only did when I disconnected the extra 4-pin. Reset of the Bios x hard, the mother has a button to do it. Thank you.

Responder
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.25
(8)

Reparación de Placa Main TV LED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 40 USD
$ 20 USD
4.73
(22)

Curso Reparación de Fuentes Conmutadas de PC y Equipos Electrónicos

Maximiliano Resch
$ 40 USD
$ 20 USD
4.6
(10)

Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off

Yamil Alarcón
$ 29 USD
$ 12 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis