Friends, this team is the same one that I have been consulting for several days, finally I found a flex that goes from the main board to the CD.I worked this way when connecting to the 110VAC socket, it turns on directly but the tray does not rotate and the tray moves out and there it remains open I press close for it to close but nothing is stinging what I do is turn off the equipment to wax it manually when reconnecting it does the same thing the ic501 heats up I have measured all the pins and it does not measure anything in short is the ba5936s how could I know if it is bad and I have this doubt about this engine the turn table that makes the tray turn out how much it measures because I measured 05.7 ohms if you can give me a better reference to repair it I thank you very much. aiwa sw 3 cd team cx-nh3m du model

friend it doesn't matter that only the tray motor and the tray motor move and where is the optician that there are two one that moves the disc and the other one that moves the saler of this one does not move only in the tray confirm me if it is synchronization I will, thank you very much

friends I have battled with this team I have synchronized it as 15 times but nothing is done to me that the micro is damaged there will be no way to reset it