⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Audio equipment

modular sony genezi MHC-GNX880 shuts down

Inocente Santiago
hace 5 años
hace 5 años
Well colleagues I have this equipment repaired and I connect it in normal demo but when I turn it on it turns on for a moment and it turns off, leaving the LED of the power key flashing between green and red I would like you to give me your suggestions to know what to check or what can be the cause of this greetings and thanks for your attention ---
Ingnio
Ingnio
2.236
hace 5 años
hace 5 años
It has a problem in the power amplifier stage, the STK must be defective. Remove the integrated and turn it on again, if the equipment hangs you must change the integrated, also check components associated with the integrated STK. Regards.
Inocente Santiago
hace 5 años

Another problem with this device is that the carousel of the discs is out of time due to a broken gear. Is it possible that it will come into protection for this? Of course the integrated thing is as much as possible greetings and thanks for answering

Responder
Ingnio
Ingnio
2.236
hace 5 años

Hello, Disconnect the flexes that go to the CD part and turn it on, if everything works fine, the problem is there.

Responder
israeloco
hace 5 años

Excuse me friend, I have the same problem with the partner, only that I already replaced the STK 412-150 and it worked, but a week later it was put back in protection by turning off after 3 or 4 seconds of turning it on, sorry that components associated with the STK could check? I hope you can help me. first of all, Thanks!

Responder
Milflo
Milflo
1.386
hace 5 años
hace 5 años
The problem is in the amplifier stage, measure if you have voltage on pin 2 of IC550, A voltage greater than 0.6v on pin 2 will activate the protection. [Img] https://cdn.yoreparo.com/uploads/ post_picture / 0002/24 / 542d2b218973a840635580721dd75c7c4a2ba363.png [/img] [img] https://cdn.yoreparo.com/uploads/imagen_post/0002/24/ef9b44db7099ecc8618a91aaf1745.png [960]
SETZUKE
hace 5 años
hace 5 años
I'm in the same case, but I have a problem, I don't have enough time and tool to repair it, can any of you repair it? I hope not to incur any fault in the forum .. Thank you
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.6
(10)

Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off

Yamil Alarcón
$ 29 USD
$ 12 USD
4.87
(15)

Curso Diseño de Amplificadores de Máxima Fidelidad

Maximiliano Resch
$ 29 USD
$ 13 USD
4.64
(11)

Curso Electrónica para Reparación de Placas

Santiago Cediel
$ 29 USD
$ 11 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis