hello that tl I have burned from a giga m8-m8 mu mica team Varistor class occurs to me that they are green, these two are facing each other, rescued the numbering but I can't find anything wtr 15do30 34685 nor do I know what it is if they know something because I can change it next to the current input of the source ln le sige a persistence then a celestial varistor then come these greens
Upload a component photo with the codes as clear as possible and a photo of the source pointed out donve van
I already sent you the images in red in sirculo is the name of the model in red where these two faced each other as they looked
I think that bridging them may seem more like condensers without heat-dependent resistors
The drawback is that you have an impedance and if there is a diagram, I'll see that
https://www.electronica-pt.com/esquema/audio/samsung-audio/samsung-mx-f870-zp-34809/ friend aki is the plane of the equi locates the cogigo that takes in the print and looks in the diagram there are ayas successful and do not forget to rate
I give doulan to download the diagram and in that place I find that I know what is the enumeration what happens is that I don't know why I can change it something that desires with the same impedance
Check what code you have and look in the diagram that goes up there are ayas that impedance has
astaora is downloading thanks for your help and I put the thumb up Asia for your help as soon as I open the diagram I commented results
hello I already found the cause of the short film was a ceramic Resistance of 471 1 KV and I replaced it and my question is what can I put between that double bridge of 15 omh 3 amper
that is not the focus to make it work
ok thanks one more and no more you would have some image of all or some ceramic resistors of 15 omh of 3 amper to go looking in the corpses of my tv plates je from now this re agradeseria if it is not a nuisance
The ceramic resistors are to replace the thermistor, and it does not come by current if not by watts. They are usually large white resistors and the value is printed on the top, both in ohms and in watts. That is why it was easier to place A spotlight instead to test if there was a short one, which is clearly there.
