Justobernardo

23

hace 5 años

Hello friend Victor, I am again, so I could put something to protect it or there is no way thanks

Victor E

65.783

hace 5 años

No, because the speaker is the amplifier's charge, the excess current will destroy the amplifier, since this is designed for an 8 ohms load.

Justobernardo

23

hace 5 años

Ok then I would have to put one of 8 ohms now I ask the Whats hurts in something or it would only have to be 8 ohms and thanks

Victor E

65.783

hace 5 años

The speaker power should always be slightly higher than the power of the amplifier, since if it is lower they usually burn. You should always consider the real power or RMS

Justobernardo

23

hace 5 años

Ok, it is a complicated detail for me, what happens is that I don't know how many Whats this amplifier is and it doesn't bring anything written friend Victor if you could help me in another ovation you helped me to locate the speaker output of this amplifier I would like one more measure or less than the speaker to buy if possible thanks

Victor E

65.783

hace 5 años

Pass me the amplifier model and tell you what speaker to buy.

Justobernardo

23

hace 5 años

Friend Victor what I could find on the card is (AMP-120W-B1 .......,. DATE: 081216 rev: B1

Victor E

65.783

hace 5 años

the speaker you buy should be 150 watts rms, 8 ohms and the inch is similar to what you have.

Justobernardo

23

hace 5 años

The twitter should be 150 wtts too? Thank you

Victor E

65.783

hace 5 años

yes better, but it has to be piezoelectric not mobile coil.

Justobernardo

23

hace 5 años

Ok Amigaso thank you for your patience now excuse my ignorance behind it brings two green and red led indicators to turn on the green that indicates that the unit is now on red so that it would be I wanted to know what it is indicating when I turn up the volume is blinking to the beat of the music thanks

Victor E

65.783

hace 5 años

and in the red LED that says?. for me it is to indicate the maximum volume limit.

Justobernardo

23

hace 5 años

Ok I thought the same thing then it is not convenient to keep it blinking since I think it would burn the amplifiers or I am getting excited because the pot is for more

Victor E

65.783

hace 5 años

I think that when it is fixed is the danger, not before.

Justobernardo

23

hace 5 años

Ok thank you very much in another ovation ask this brings pendrib input Minority good the problem is that when injecting the 12 v what it indicates in the circuit turns on but all blue nothing more and heats the integrated would have arrangement or would have to completely change the cexion thanks or " you will say this has more problems haha

Victor E

65.783

hace 5 años

If it is a micro problem, it would be convenient to change the plate. You have to control the tensions. Do not forget to accept my proposed solution. Greetings. Happy holidays.

Justobernardo

23

hace 5 años

Ok Friendly happy holidays also for you and your whole family thank you for helping me on this occasion until the next one a scorched thank you

Victor E

65.783

hace 5 años

ok greetings merry christmas

Justobernardo

23

hace 5 años

Hello friend Victor excuse me one last question I was offered a speaker an xpro 350 RMS my question is that if it is convenient for my empowered or would have to buy the one you told me just thank you

Victor E

65.783

hace 5 años

do not put a lot of speakers because if the amplifier is small it will not sound anything later. Look at the speaker of what power the equipment brings and buy another similar one.