⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Water Heaters (Calefones)

Instant water heater Orbis a keypad turns off when mixed with cold wat

MARCELO-ARG:
hace 5 años
hace 5 años
Hello good afternoon!! I have a 14-liter Orbis instant water heater which works well until I try to mix it with cold water, what I notice is that the hot water pressure is a little lower than the cold one and when I try to combine both to warm the water It goes out, this happens more in the shower than it is a new fv external monocommand where the water is hot or cold I can not have midpoint. From now, thank you so mucho for your attention!!
Comentar
servimat1
servimat1
servimat1
138.835
hace 5 años
hace 5 años
Hi. The main problem would be in the faucet. This type is to greatly reduce the flow of water, so the heater is turned off. Is it a new installation? Is it a house or building? regards
Comentar
MARCELO-ARG:
hace 5 años

It is a new house I moved a month ago and I placed the same water heater that I had in another house, everything is new except the water heater, the pipe is 3/4 inch so I had to use 1/2 reducers to connect the water heater

Responder
servimat1
servimat1
servimat1
138.835
hace 5 años

It must be under the tank. It would be necessary to see if they tested the installation for reasons of flow. Is the water heater moderately new?

Responder
MARCELO-ARG:
hace 5 años

The water heater is 5 years old, the pipe was tested, but I just tried to disconnect the hose that feeds the flower and the water heater does not turn off, that is, perfect mixture, can it be solved with a pressurizing pump?

Responder
servimat1
servimat1
servimat1
138.835
hace 5 años

So is. Ideally, a pressurizer at the base of the tank should be used to increase the pressure of both cold and hot. it would have to be placed in the tank collector with a bypass for an eventual prolonged power cut.

Responder
MARCELO-ARG:
hace 5 años

Ok thank you very much for your help servimat1

Responder
servimat1
servimat1
servimat1
138.835
hace 5 años

Nice to help you. If you are from Argentina, place a Rowa brand that is eternal. The SFL09 will be enough. regards

Responder
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.93
(14)

Curso Reparación de Equipos de Audio de Alta Fidelidad
Maximiliano Resch
$ 60 USD
$ 20 USD
COMPRAR
4.73
(22)

Curso Reparación de Fuentes Conmutadas de PC y Equipos Electrónicos
Maximiliano Resch
$ 40 USD
$ 20 USD
COMPRAR
4.6
(10)

Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off
Yamil Alarcón
$ 29 USD
$ 12 USD
COMPRAR
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis