⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Water Heaters (Calefones)

Gas scorpion water heater

Horacio Piccinini

hace 5 años

Hello everyone, install an 80 liter scorch gas water heater with an analyzer pilot, light the pilot well and stay on, when I turn the thermostat, I turn on the burner but the pilot flame is greatly reduced and therefore does not heat the thermocouple and turns off. I would appreciate your comments. Regards Horace

Comentar



mariotti luis marcos

19.266

hace 5 años



hace 5 años

Hello, if the pilot's flame is reduced a lot, it may be a lack of gas pressure, check the gas connections, make sure the stopcock is fully open.

Comentar

Horacio Piccinini

hace 5 años

Hello Thank you for the answer I will check but I think the gas tap is fine, as an additional I ask you that I am not sure if the exit to the outside is in conditions could be obstructed it is not seen because it is inside the wall. Is the output important with respect to the pilot gas analyzer that has the thermos?



Responder

Horacio Piccinini

hace 5 años

The solution was to eliminate the 3/8 copper pipe and continue the 3/4 pipe to the thermos. The cause was the lack of gas pressure. Thank you Regards Horace

Comentar

mariotti luis marcos

19.266

hace 5 años

Hi, I'm glad to know that you could solve the problem. The gas outlet must be executed according to the regulations, as indicated in the installation manual.



Responder