⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Water Heaters (Calefones)

3/4 nipple input and output infernocarcomidos by rheen thermo oxide

Angel 1pc

hace 6 años

hello: I have a 50-liter natural gas rheen thermos with lower inlet, 3 years of use and the thread threads of the nipples are all rotten. My question is if I exchange them for other bronze nipples what type of thread sealant could use (that supports the heat of the bottom of the tank and the water)

Comentar

Angel 1pc

hace 6 años

hello: does anyone know what sealer to use for this case of water and heat from the bottom of the thermos?



Responder

mariotti luis marcos

19.266

hace 6 años

Hello, good angel, I'm glad to know that you were able to solve the problem, greetings from miramar bs as



Responder

servimat1

138.835

hace 6 años

Hi. You can use Hidro 3 green sealant (H3) with some hemp strands. It will never lose and if it is of lower load it does not receive much temperature. This corrosion is due to the galvanic torque that originates from being different metals in contact. Regards

Comentar

Angel 1pc

hace 6 años

Hello: I would have to leave it for more than 24 hours drying out because on other occasions with less time it gave me losses



Responder

servimat1

138.835

hace 6 años

There is no need to let it dry. just make skin in 15 minutes. The hemp if it gets wet expands closing the possible leak.



Responder



mariotti luis marcos

19.266

hace 6 años



hace 6 años

Hello: you can enable it at the moment, place hemp in the lower part of the thread, then the h3 sealant on tight weapons and you can use it at the moment you should not lose, see if the cupla where you screw the nipple has a stop if you can put a gasket fiber with that there would be no possibility of loss if you do not know how to use hemp you can use high-density teflon greetings

Comentar

Angel 1pc

hace 6 años

hello: in the week I will try, I hope to loosen the nipples, they would seem to be placed with another type of sealant that if it solidified it will complicate me and there I will ask for more ideas.



Responder

mariotti luis marcos

19.266

hace 6 años

If they use a white sealer, it is similar to hydro3, but the galvanized nipples are seized, do not overdo it if they do not loosen heating with a blowtorch



Responder