⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Water Heaters (Calefones)

Change of plastic pipes (orbis heater)

Diego Maciel

hace 6 años

Good day. I have an Orbis water heater that began to lose water because of a small rubber pipe that goes (if I'm not mistaken) from the venturi to the diaphragm. Buy the replacement but I'm not sure how it is changed. Are they under pressure or are they screwed? Try to pull it out but I don't notice that it gives in, and I don't want to end up breaking something.

Thank you.

Comentar



mariotti luis marcos

19.266

hace 6 años



hace 6 años

hello: to change the hoses first cut off the water and the gas then I opened an AC tap to release the pressure disassemble the venturi assembly and water chamber observe the position of the hoses so that they do not cross. in the venturi it has a screw that holds the screw out and pulling out of the side of the diaphragm has an insurance, that replacement also comes much better quality copper any doubt comments greetings

Comentar

servimat1

138.835

hace 6 años

Hi. There are threaded models and pressure models and others with a lock. Upload a photo of the area to tell you how to take them out. Regards

Comentar

Diego Maciel

hace 6 años

There I edited and uploaded the photo, if it does not look good I try to take it in another angle.



Responder

servimat1

138.835

hace 6 años

This picture is fine. These plastic pipes are simply changed by removing the screw you see in the Ventury's body. They go alone in this way, under pressure and with a small rubber gasket.



Responder