⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Water Heaters (Calefones)

Ionized 14lts Nex brand heater. Sometimes it turns on and hits an expl

cristian87
hace 6 años
hace 6 años
Hello good afternoon, I consult my problem ... I had a hot water tank and I replaced it with a Nex brand ionized heater, I placed a rowa pressurizing pump, the problem is that when I open the hot water to turn on it feels that it sparks and apparently It accumulates a lot of gas by launching slight explosions. I thought there might be the batteries, I changed them and it's the same. Today it is costing you a lot more than to light and when you start sparking and not ignite you feel a bit of a gas smell. I clarify that the water I bought used with 5 months of use is in good condition. Could you help me? Thank you
servimat1
servimat1
138.835
hace 6 años
hace 6 años
Hi. Explosions occur when gas accumulates. This may be because the pilot's flame is very small or the sparks in your case are not effective on or directly on the burner. Verify this and you can gently move the sparks to bring them closer to the burner. Regards
cristian87
hace 6 años

Hello, thank you very much, it was definitely the sparks I moved them and it starts quickly, I still have to finish regulating the burners with respect to the peaks although it starts now there no more, it is still a little rough does not start with that softness, it explodes but very little. Will that be normal? Does the burner have to be pointing directly at the peaks?

Responder
servimat1
servimat1
138.835
hace 6 años

So that the gas does not accumulate and there are no explosions you must modify in detail the sparks in the burner and regulate the air of the burners. The entire burner is usually run on some models. With this it will not make explosions or very dim.

Responder
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.84
(25)

Curso Práctico de Reparación y Bobinado de Motores Eléctricos

Héctor Castiñeira
$ 60 USD
$ 20 USD
4.73
(22)

Curso Reparación de Fuentes Conmutadas de PC y Equipos Electrónicos

Maximiliano Resch
$ 40 USD
$ 20 USD
4.64
(45)

Curso Tecnología Inverter - Fabricación de probadores y herramientas

Yamil Alarcón
$ 240 USD
$ 40 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis